Table of Contents
Advertisement
Compatibility & Lamps
Adjusting the dimming range
On initial setup, LightwaveRF Dimmers are pre-programmed to allow a
moderate range of dimming for any connected lamps. If desired, this range
can be extended by following the instructions below.
The reason for allowing modifications to the dimming range is to maximise
compatibility with dimmable LED lamps (bulbs). In some cases, LED lamps
may flicker slightly at high or low brightness levels, especially if there is only
a modest overall circuit load (under 10W). Stability can be achieved by a
very slight adjustment to the dimming range of the LightwaveRF Dimmer.
The default setting (smallest dimming range) is the most stable for LEDs. If
the LEDs perform normally at this setting (most cases), then the range can
be increased (if desired) using the following method.
1.
On the dimmer switch, press and hold
down both the 'on' and 'o ' buttons on
one of the gangs until the blue and amber
LEDs flash alternately then release them.
The dimmer switch is now in linking
mode.
Advertisement
Table of Contents
