Brother MFC-J2330DW Online User's Manual page 566

Error Message
Low Temperature
Media is Full.
No Caller ID
No Device
No File
No Paper Fed
No Paper Fed [Tray
#1]
No Paper Fed [Tray
#2]
Cause
Another sheet of paper was placed in the
manual feed slot before the touchscreen
prompted you to load another sheet of
paper.
Paper dust has accumulated on the
surface of the paper pick-up rollers.
The room temperature is too low.
The USB flash drive you are using already
contains 999 files.
The USB flash drive you are using does
not have enough free space to scan the
document.
There is no incoming call history. You did
not receive calls or you have not
subscribed to the Caller ID service from
your telephone company.
When configuring the Wi-Fi Direct
network, the Brother machine cannot find
your mobile device.
The USB flash drive in the media drive
does not contain a .JPG file.
The machine is out of paper or paper is
not correctly loaded in the paper tray.
The paper was not inserted in the centre
position of the manual feed slot.
The Jam Clear Cover is not closed
correctly.
Action
load another sheet of paper before you
feed the next sheet of paper in the manual
feed slot.
Remove the jammed paper.
See Related Information: Printer Jam or
Paper Jam.
Clean the paper pick-up rollers.
See Related Information: Clean the Paper
Pick-up Rollers.
After warming the room, allow the
machine to warm up to room temperature.
Try again when the machine has warmed
up.
Your machine can only save to your USB
flash drive if it contains fewer than 999
files. Delete unused files and try again.
Delete unused files from your USB flash
drive to make some free space, and then
try again.
To use the Caller ID feature, contact your
telephone company.
See Related Information: Caller ID.
• Make sure your machine and mobile
device are in the Wi-Fi Direct mode.
• Move the mobile device closer to your
Brother machine.
• Move your Brother machine and the
mobile device to an obstruction-free
area.
• If you are manually configuring the Wi-
Fi Direct network, make sure you have
entered the correct password.
• If your mobile device has a
configuration page for how to obtain
an IP address, make sure the IP
address of your mobile device has
been configured via DHCP.
Put the correct USB flash drive into the
slot again.
Do one of the following:
• Refill the paper tray, and then follow
the LCD instructions.
• Remove and reload the paper, and
then follow the LCD instructions.
See Related Information: Load Paper.
Remove the paper and reinsert it in the
centre of the manual feed slot, and then
follow the LCD instructions.
See Related Information: Load Paper in
the Manual Feed Slot.
Make sure the Jam Clear Cover is closed
evenly at both ends.
See Related Information: Printer Jam or
Paper Jam.
559