Table of Contents
Advertisement
Functional Description
Specifications
Max. Air Pressure
Air Inlet
Hopper Capacity
Air Consumption
Initial tool Set up/assembly
Read the entIRe ImpORtant
SaFety InFORmatIOn section at the
beginning of this manual including
all text under subheadings therein
before set up or use of this product.
note: For additional information regarding the
parts listed in the following pages, refer to the
Assembly Diagram near the end of this manual.
note: This air tool may be shipped with a protective plug
covering the air inlet. Remove this plug before set up.
air Supply Setup
tO pRevent SeRIOuS InjuRy
FROm explOSIOn:
use only clean, dry, regulated, compressed
air to power this tool. Do not use oxygen,
carbon dioxide, combustible gases, or any other
bottled gas as a power source for this tool.
1. To attach an air hose - 3/8" - 18 NPT (not included) to
the Blast Gun, wrap approximately 3" of pipe thread
sealer tape (not included) around the male threads
at the end of the air hose. Then, firmly tighten the
air hose onto the Air Inlet (2) of the Blaster Gun.
2. Incorporate a filter, regulator with pressure gauge,
in-line shutoff valve, and quick coupler for best
service, as shown on Figure A on page 6 and
Figure B on page 7. an in-line shutoff ball
valve is an important safety device because
it controls the air supply even if the air hose
is ruptured. the shutoff valve should be a
ball valve because it can be closed quickly.
SKU 95793
90 PSI
1/4 IN. - 18 NPT
20 OZ.
7 CFM @ 90 PSI
For technical questions, please call 1-800-444-3353.
note: An oiler system should not be used
with this tool. The oil will mix with the material
being propelled, causing poor results.
3. Attach an air hose to the compressor's air outlet.
Connect the air hose to the air inlet of the tool.
Other components, such as a coupler plug
and quick coupler, will make operation
more efficient, but are not required.
WaRnInG! tO pRevent SeRIOuS InjuRy
FROm aCCIDental OpeRatIOn:
Do not install a female quick coupler on the tool.
Such a coupler contains an air valve that will
allow the air tool to retain pressure and operate
accidentally after the air supply is disconnected.
note: Air flow, and therefore tool performance, can
be hindered by undersized air supply components.
4. The air hose must be long enough to reach
the work area with enough extra length to
allow free movement while working.
5. Close the in-line shutoff valve between
the compressor and the tool.
6. Turn on the air compressor according to
the manufacturer's directions and allow it
to build up pressure until it cycles off.
7. Adjust the air compressor's output regulator so
that the air output is enough to properly power
the tool, but the output will not exceed the tool's
maximum air pressure of 90 PSI at any time.
Adjust the pressure gradually, while checking the
air output gauge to set the right pressure range.
8. Inspect the air connections for leaks.
Repair any leaks found.
9. If the tool will not be used at this time, turn off and
detach the air supply and safely discharge any
residual air pressure to prevent accidental operation.
note: Residual air pressure should not be present after
the tool is disconnected from the air supply. However,
it is a good safety measure to attempt to discharge
the tool in a safe fashion after disconnecting to ensure
that the tool is disconnected and unpowered.
Page 5
Advertisement
Table of Contents
