Table of Contents
Advertisement
FUNCTIONAL DESCRIPTION
Specifications
Operating Air Pressure
Maximum Air Pressure
Air Inlet
Blows Per Minute
Air Consumption
Components and Controls
The only control is the Trigger (3). See
parts list and assembly diagram pages 13
and 14.
INITIAL TOOL SET UP/
ASSEMBLY
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Unpacking
When unpacking, make sure that
the item is intact and undamaged. If any
parts are missing or broken, please call
Harbor Freight Tools at the number shown
throughout the manual as soon as pos-
sible.
• This air tool may be shipped with a
protective plug covering the air inlet.
Remove this plug before set up.
SKU 98672
90 PSI
90 PSI
1/4" -18 NPT Female
4,500
3.2 CFM @ 90 PSI
For technical questions, please call 1-800-444-3353.
Air Supply
Use only clean, dry, regulated,
compressed air to power this
tool. Do not use oxygen,
carbon dioxide, combustible
gases, or any other bottled
gas as a power source for this
tool.
1.
Incorporate an in-line oiler, shut-off
valve, regulator with pressure gauge,
and filter for best service, as shown in
the diagram above. An in-line shut-
off valve is an important safety
device because it controls the air
supply even if the air hose is rup-
tured.
Note: If an automatic oiler system is not
used, add a few drops of Pneumatic
Tool Oil to the airline connection be-
fore operation. Add a few more drops
after each hour of continual use.
2.
Attach an air hose to the compres-
sor's air outlet. Connect the air hose
to the air inlet of the tool. Other com-
TO PREVENT
EXPLOSION:
Page 7
Advertisement
Table of Contents
