Troubleshooting; Technical Support; Disposal Of The Appliance - TECNOEKA EKF 523 NUD Operating And Instruction Manual

Hide thumbs

Table Of Contents

Table of Contents

6. TROUBLESHOOTING

Type of fault

Control panel warning

lights totally off

(The oven does not work)

Cooking cycle set: the oven

does not work

Automatic humidifier

active: no humidity/steam

production in the cooking

chamber

Closed door: steam escapes

through the gasket

The oven does not cook

evenly

Lamp (LED) in the cooking

chamber does not work

The thermal safety device is

activated continuously

The thermal safety device is

activated continuously

7. TECHNICAL SUPPORT

Before leaving the factory this appliance has been calibrated and tested by experienced and skilled

personnel in order to obtain the best operating results. Any repair or calibration must be carried

out with the utmost care and attention, using only original parts.

That is why it is required to always contact the Dealer who has sold the appliance or our nearest

Technical Support Centre, specifying the kind of failure and the model of the appliance you have.

The parts required for adaptation to different types of gas are provided with the appliance hence

supplied upon sale or delivery.

For servicing needs the user may contact Tecnoeka on the numbers shown on the cover, or refer to

the website www.tecnoeka.com.

8. DISPOSAL OF THE APPLIANCE

In accordance with Directive 2012/19/EU on the disposal of waste electrical and

electronic equipment, the crossed-out wheeled bin symbol on the equipment indicates

that the product was placed on the market after 13 August 2015, and that at the end

of its services life it must be disposed of separately from other waste.

At the end of the appliance's service life, the user must, therefore, deliver it to the

appropriate centres (recycling centres) for the separate collection of electrical and

electronic waste.

All TECNOEKA appliances are made of recyclable metal materials (stainless steel,

galvanised sheet metal, iron, copper, aluminium, etc.) which make up more than 90%

of the total weight of the appliance. Before disposing of the appliance, it is

recommended to make it unusable by removing the power supply cable and removing

the mechanism for closing compartments and/or openings, if any.

The separate waste collection and subsequent treatment, recovery and disposal, are conducive to the

production of equipment with recycled materials and reduce the negative effects on the environment and

health possibly caused by incorrect waste handling. Illegal disposal of the product by the user entails the

application of administrative penalties.

Cause of the fault

- Non-compliant connection to the power

mains

- No mains voltage

- Safety thermal device triggered

- Door open or ajar

- Door microswich damaged

- Non-compliant water mains connection

- Closed stopcock

- Obstructed water inlet filter

- Damaged water inlet solenoid valve

- Non-compliant gasket assembly

- Damaged gasket

- Handle "nose" adjusted incorrectly

- One of the motors is down or operates at

low speed

- The motors do not reverse direction

- Resistor not powered or damaged

- Lamp (LED) damaged

- Damaged device

- Control thermostat damaged

Corrective action

- Check the connection to the mains

- Restore the power supply voltage