Jøtul F160 Series Installation And Operating Instructions Manual page 14

ENGLISH
Wood consumption
Use of wood, with nominal heat emission: Approx. 1,6 kg/h.
Another important factor for proper fuel consumption is that
the logs are the correct size. The size of the logs should be:
Kindling:
Length: 23-33 cm
Diameter: 2 - 5 cm
Amount per fi re: 6 - 8 pieces
Daily use
Firewood (split logs):
Length: 23 - 33 cm
Diameter: Approx. 8 cm
Intervals for adding wood: Approximately every 45 minutes
Size of the fi re: 1,2 kg
Amount per load: 2 pieces
Nominal heat output and effi ciency are based on heating
with total 1,15 kg beech (2 logs). The air vent was pulled
out 24 mm.
Nominal heat emission is achieved when the air vent is
open approximately 60 %.
Maximum use
Maximum load: 2,9 kg/h (maximum 3 pieces/2,2 kg per load).
5.2 Ash removal
Jøtul F 164 / F 165 / F 166 / F 167 have an ash pan which makes
it easy to remove the ash.
Fig. 12
1. Scrape the ash through the grate in the base plate and into
the ash pan. Use a glove to grab the handle on the ash pan.
2. Make sure that the ash pan doesn't fi ll up so high that it
keeps ash from coming through the grate into the pan.
14
6.0 Service
Warning! Any unauthorised change to the product is not
allowed.
Only use original spare parts.
6.1 Changing the burn plates/inner
bottom plate
Fig. 13
1. Lift the baffl e (Fig. 13 A) up carefully.
2. Remove one of the side burn plates (Fig. 12 E) by lifting
them up a little and then out. (Be aware if using tools, that
vermiculite plates may be damaged by rough handling).
3. Remove the baffl e.
4. Remove the other side burn plate.
5. Unscrew the M8x25 mm screw on the rear burn plate (Fig.
13 F) and remove the burn plate.
6. Then lift up and remove the inner bottom plate (Fig. 13 C).
Follow the same procedure for installation, but in the opposite
sequence.