Jøtul F160 Series Installation And Operating Instructions Manual page 11

4.5 Adjusting door mechanism
The product is delivered with a selfclosing doormechanism. If
necessary this can be adjusted.
Fig. 4 g
A
For Jøtul F 164 and Jøtul F 165:
1. Remove the heat shield (Fig. 4 A).
2. Loosen the screw (Fig. 4 B).
3. Adjust the spring by moving the bracket.
4. Tighten the screw.
5. Refi t the heat shield.
For Jøtul F 166 and Jøtul F 167:
1. Loosen the screw (Fig. 4 B).
2. Adjust the spring by moving the bracket.
3. Tighten the screw.
4.6 Leveling the fi replace
Fig. 5
NB! If a glass front plate is used, raise the base 6mm up
from the fl oor. Then slide the glass front plate underneath
the front of the base.
4.7 Fitting the fl ue pipe with the
rear outlet
The product is supplied from the factory with the smoke outlet
fi tted for the top outlet.
NB! Proceed as follows for installation with a rear outlet:
Fig. 6
B
1.
2.
3.
4.
5.
Fig. 7
6.
Lift the baffl e (Fig. 6 A) up carefully.
Remove one of the side burn plates by lifting them up a
little and then out. (Be aware if using tools, that vermiculite
plates may be damaged by rough handling).
Remove the baffl e.
Remove the other side burn plate.
Remove the exhaust defl ectors (Fig. 6 B).
Unscrew the screws (Fig. 7 A) and remove the smoke
outlet (Fig. 7 B) from the top outlet from the inside of the
burn chamber.
ENGLISH
11