Mars Comfort-Aire Century VCD24 SA Series Installation And Owner's Manual page 8

Wired controller, hyper heat single-zone
Hide thumbs Also See for Comfort-Aire Century VCD24 SA Series:
Table of Contents

Advertisement

3. Installation method
NOTE: The PCB is mounted in the upper part of the wired
controller. Be careful not to damage the board
with the slot screwdriver.
3. Fasten the back plate of the wired controller
For exposed mounting, fasten the back plate on the wall with
the 3 screws (M4×20) and plugs. (Fig.3-3)
Use two M4X25 screws to install the back cover on the 86
switch box, and use one M3.9X25 screw to x to the wall.
5
Back plate
Fig 3-3
Screw hole fixed on the wall, use one φ
Screw hole installed on 86 switch box, use two
Fig 3-4
Wired Controller IOM - VCDxxSA
Screws (M4×20)
mm
3.9X25
mm
M3.9X25

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents