Using The Ceiling Rail Adapter; Connecting Required Cables - Aruba 340 Series Installation Manual

Using the Ceiling Rail Adapter

1. Pull the necessary cables through a prepared hole in the ceiling tile near where the access point will be placed.
2. Place the adapter against the back of the access point with the adapter at an angle of approximately 30 degrees to the
tabs (see Figure
3. Twist the adapter clockwise until it snaps into place in the tabs (see
Figure 7 Attaching the Ceiling Rail Adapter
4. If necessary, connect the console cable to the console port on the back of the access point.
5. Hold the access point next to the ceiling tile rail with the ceiling tile rail mounting slots at approximately a 30-degree
angle to the ceiling tile rail (see
6. Pushing toward the ceiling tile, rotate the access point clockwise until the device clicks into place on the ceiling tile rail.
Figure 8 Mounting the Access Point
7. For the AP-344, install the external antennas onto the antenna connectors on front of the access point by screwing
them clockwise into place. Once attached to the access point, position the antennas as needed.

Connecting Required Cables

Install cables in accordance with all applicable local and national regulations and practices.
Software
For instructions on choosing operating modes and initial software configuration, refer to the most current version of the
8
7).
Figure 8). Make sure that any cable slack is above the ceiling tile.
Figure 7).
Aruba 340 Series Campus Access Point | Installation Guide