Table of Contents
Advertisement
1. Remove the single screw (M2x3) that secures the WLAN antenna cable bracket to the system board.
2. Lift and remove the WLAN antenna cable bracket from the system board.
3. Disconnect the two antenna cables that are connected to the WLAN module on the system board.
4. Remove the single screw (M2x3) that secures the display-cable bracket to the system board. Lift and remove the display-
cable bracket from the system board.
5. Open the latch and disconnect the display cable from the connector on the system board.
6. Open the system to 120 degrees.
Removing and installing components
53
Advertisement
Table of Contents
