Table of Contents
Advertisement
1. Remove the single screw (M2x3) that secures the WWAN-card bracket to the system board.
2. Remove the WWAN-card bracket and disconnect the black and white antenna cables from the WWAN card.
3. Slide and remove the WWAN card from the WWAN-card slot on the system board.
Installing the WWAN card (2-in-1)
If you are replacing a component, remove the existing component before performing the installation procedure.
NOTE:
The following steps are for computers with WWAN support.
The following image indicates the location of the WWAN card and provides a visual representation of the installation procedure.
Removing and installing components
19
Advertisement
Table of Contents
