Table of Contents
Advertisement
– Cleaning and maintenance reserved for the user must not be
carried out by unsupervised children.
– Before intervening on the system (maintenance, cleaning), al-
ways disconnect the product from the mains power supply and
from any batteries.
– Check the system frequently.
– The packing materials of the product must be disposed of in
compliance with local regulations.
– Before connecting the power supply unit to the mains, make
sure that the LEDs are properly connected to the receiver.
– Incorrect connection of the LED diodes (reversed polarity) could
damage them, therefore be very careful to position the poles
correctly when connecting them.
– When it is switched on, the receiver resumes the same condition
prior to being switched off.
– The product must not be incorporated or installed in insulating
products such as mineral wool or polystyrene, or similar prod-
ucts.
PRODUCT DESCRIPTION AND INTENDED
2
USE
2
PRODUCT DESCRIPTION AND INTENDED USE
Led Control Range TTDRGB is a "dimmer" combined with a radio re-
ceiver that is used to control RGB (Red-Green-Blue) LEDs. For it to work,
it must be powered by a 24 VDC external power supply unit (not supplied).
Through a paired transmitter it is possible to set the programmes. The
LEDs are controlled exclusively via radio through the paired transmitters.
a
CAUTION! – Any use other than that specified herein or in
environmental conditions other than those stated in this
manual is to be considered improper and is strictly for-
bidden!
2.1
LIST OF CONSTITUENT PARTS
The TTDRGB is made up of a casing that protects the command and
control boards. "Figure 1" shows the main parts making up the TTDRGB.
1
A Connection to the LED strips
B Connection to the 24Vdc power supply unit
B
3
INSTALLATION
3
INSTALLATION
3.1
PRE-INSTALLATION CHECKS
Before proceeding with the product's installation, it is necessary to:
– check the integrity of the supply
– check that all the materials are in good working order and suited to the
intended use
– check that all operating conditions comply with that specified in the "
Product usage limits" paragraph and in the "TECHNICAL SPECIFI-
CATIONS" chapter
– check that the chosen installation location is compatible with the prod-
uct's overall dimensions (see "Figure 2")
– check that the surface chosen for installing the product is solid and can
ensure stable attachment
– make sure that the installation area is not subject to flooding; if neces-
sary, the product must be installed appropriately raised above ground
level
– check that the space around the product allows safe and easy access.
3.2
PRODUCT USAGE LIMITS
The product can be used exclusively with 24Vdc power supply units
and with 24 V LED strips of adequate power (refer to the "TECHNICAL
SPECIFICATIONS" chapter).
3.3
PRODUCT IDENTIFICATION AND OVERALL
DIMENSIONS
The overall dimensions and label (A) that allow for identifying the product
are shown in "Figure 2".
2
A
A
Tc point
9 8
m m
ENGLISH – 3
Advertisement
Table of Contents
