Page 1
Operating & Installation Instructions for ACTpro 4200 4 Door Controller & 3 Amp Power Supply 18-00074...
Page 2
ACTpro 4200 Operating and Installation Manual Rev 1.0 Contents PRODUCT FEATURES..............................2 PRODUCT SPECIFICATION ............................2 INSTALLATION NOTES ..............................2 ORDERING INFORMATION ............................2 POWER BUDGET CALCULATION ..........................3 BATTERY BACK-UP ..............................3 CONFIGURING ACTpro 4200 .............................4 Diagrams ACTpro 4200 Installation Diagram..........................5 Unit C1, South City Business Centre, Tallaght, Dublin 24, Ireland.
Page 3
• Mains power should be connected to the ACTpro 4200 by a licensed electrician in accordance with local and national codes.
Page 4
ACT recommends the use of a separated power supply for the locks. The power budget calculation below shows that when all the 4 doors of the ACTpro 4200 are used with ACTpro-X Entry and Exit readers that the total current consumption is 2000mA. This gives headroom of 1000mA.
Page 5
12. Check that the controller does not report any door offline. Ensure there are no faults reported on the controller display. 13. For ACTWin pro users, make sure the Mains Fault box is ticked for the ACTpro 4200 doors 3 & 14. Tamper on the ACTpro4200 will be reported as door 3. Therefore in ACTWin software disable tamper reporting on door 1 and enable it on door 3.
Page 6
ACTpro 4200 Operating and Installation Manual ACTpro 4200 Operating and Installation Manual Rev 1.0 Rev 1.0...
Page 7
ACTpro 4200 Operating and Installation Manual Rev 1.0...
Need help?
Do you have a question about the ACTpro 4200 and is the answer not in the manual?
Questions and answers