Table of Contents
Advertisement
1
8
9
10
XLR and JACK TRS STEREO INPUT (BAL / UNBAL). The system accepts JACK TRS or XLR
1
input connectors. These balanced inputs can be used to connect balanced or unbalanced
line level audio sources.
RCA INPUT (UNBAL). The system accepts RCA input connectors. These unbalanced
2
inputs can be used to connect unbalanced audio sources at line level.
STEREO XLR OUTPUTS (BAL). Balanced stereo outputs for connecting the monitors
3
adopted in the system. The studio monitors connected to these outputs are subject to the
action of the high pass filter (CROSSOVER KNOB -
PHASE SWITCH. This switch allows you to reverse the phase of the input signal by
4
180°; useful, in some cases, to correct an imperfect positioning of AYRA PRO10 SUB
compared to the connected monitors.
INPUT VOLUME. This potentiometer adjusts the input level to the AYRA PRO10 SUB
5
subwoofer.
CROSSOVER KNOB. This potentiometer allows you to select the crossover frequency
6
between the AYRA PRO10 SUB subwoofer and the connected monitors. The adjustment
allows cutting frequencies from 50Hz to 120Hz, allowing the subwoofer to reproduce the
selected low frequencies.
BYPASS FOOTSWITCH. Connect an unlatch footswitch to this TS jack to bypass the
7
subwoofer function. When the subwoofer is bypassed the signal flows from stereo inputs
to stereo outputs bypassing also the crossover control. Press again the footswitch to
restore the subwoofer function.
MAIN POWER SWITCH. The power switch turns the AC power on and off.
8
6
7
5
6
4
2
3
).
6
REAR
PANEL
Advertisement
Table of Contents
