Rear Panel Features And Controls - RCF SUB 8008-AS Owner's Manual

3. REAR PANEL FEATURES AND CONTROLS

1
FEMALE XLR INPUTS L and R The system accepts XLR
input connectors�
2
MALE XLR SIGNAL OUTPUTS The output XLR connectors
provide a loop through for speakers daisy chaining� The
balanced connectors are connected in parallel, and can be
used to send the audio signal to other amplified speakers or
supplementary amplifiers�
3
SYSTEM SET UP ENCODER
4
GAIN REDUCTION / POWER LED
-
POWER LED This green LED lights up when the speaker is
connected to the main power supply�
-
GAIN REDUCTION LED Pushing the encoder once, the
gain reduction indicator lights up green� Then, rotating the
encoder, the gain level can be set to the right level�
5
DELAY / SIGNAL LED
-
DELAY LED Pushing the encoder twice, the delay indicator
lights up green� Then, rotate the encoder to delay the speaker�
The delay is expressed in meters�
-
SIGNAL LED The signal indicator lights up green if there is
an audio signal on the main�
6
PRESET / LIMITER LED
-
PRESET LED Pushing the encoder three times, the preset
indicator lights up green� Then rotate the encoder to load the
right preset to the speaker�
-
LIMITER LED The amplifier has a built-in limiter circuit
to prevent any amplifier clipping or transducers overdrive�
When the soft clipping circuit is active, the LED blinks RED� It
is okay if the limiter LED blinks occasionally� If the LED lights
continuously, turn down the signal level�
7
SYSTEM SET UP DISPLAY It displays the system setting
values�
8
LINK/XOVER SELECTOR When the selector is set to LINK
position, the input signal is sent directly to the output signal�
When the selector is set in XOVER position, a crossovered
signal will be applied to the outputs to optimize the signal sent
to any speaker connected�
9
AC POWER INPUT PowerCON TRUE1 TOP IP-Rated power
connection�
10
AC OUTPUT LINK Sends the AC power to another speaker�
Power link: 100-120V~ max 1300W l 200-240V~MAX 2800W
1
7
8
5
4 6
2
3
2
9 10
7