Table of Contents
Advertisement
Use and Maintenance Manual model "H10 V SHAPE - H12 V SHAPE"
8.3 DESCRIPTION OF THE HANDHELD DEVICE DISPLAY
The handheld device display is as follows:
2
3
After 20 seconds of inactivity, the display on the
handheld device blacks out and passes to "SLEEP"
mode, maintaining the remote connection with the
appliance. The display re-enables only by pressing
the
key.
Icon indicating the status of the appliance
1
(see "Concise icons diagram").
Displays the ambient temperature detected by the
2
handheld device. Furthermore, pressing the scroll key
allows display of the temperature setting, which
can be edited using the two scroll keys
Confirmation of each variation takes place
automatically within 3 seconds of editing the data,
or by pressing the confirm key
confirms the change
was made.
It shows boiler water actual temperature as detected
3
by the probe placed upstream in the system.
Moreover, temperature settings can be viewed by
pressing
and then edited by pressing the two
scroll buttons
Any change in temperature settings is confirmed
either automatically - within 3 seconds from the last
change – or by pressing
signal will confirm the change.
It shows power settings.
4
STAND-BY SCREEN
. An acoustic signal
OK
.
button. An acoustic
OK
1
From STAND-BY mode, pressing
an overview of the actual and active device status,
as shown in the following figure:
4
Pressing
OK
power by means of
POWER: it shows the appliance power, which can be
- MINIMUM: minimum editable power
- MAXIMUM: maximum editable power (see
specific section)
- ECO: product modulation when setting
.
values are reached;
- SANI: indicates dedicated power – in case
of need – if a rapid DHW kit is installed or either a par-
ticular system has been set.
Each time the appliance is turned on it always
activates at maximum power;
PUMP: The word ON indicates that the circulator is
active and is in the process of circulating water in the
dwelling system.
3-WAY VALVE: Indicates the positioning of any
three-way valve installed, if in the presence of DHW
exchanger or DHW tank.
PRESSURE: Indicates the actual pressure of the
system read by the transducer, placed on the pro-
duct upstream.
8.4 FLAT BATTERIES SIGNAL
If batteries are flat, the display presents a symbol
which indicates their limit status, however
maintaining the functions enabled of the
handheld device.
As soon as the level of the batteries does not allow
any remote communication, the handheld device
displays, on the full screen, the image of the flat bat-
tery, blocking all the functions connected to it until
the batteries are replaced.
22
ENGLISH
allows to obtain
allows to edit the appliance working
scroll buttons.
Advertisement
Table of Contents
