Table of Contents
Advertisement
Use and Maintenance Manual model "H10 V SHAPE - H12 V SHAPE"
3.7 DOCUMENTATION TO ISSUE
When installation is concluded, the installation tech-
nician must deliver to the user:
• the use and maintenance booklet of the
appliance supplied by the manufacturer;
• the technical documentation of the accessories
used and subject to maintenance;
• the documentation relevant to the evacuation
system of combustion products;
• The system booklet (where planned);
• the documentation certifying installation;
The useful documentation for installation liability
must include:
• a detailed description (also including photo
graphs) of the presence of other heat generators;
• Declaration of Conformity of the system
to standard (M.D. 37/08);
• general description, or diagram or
photographic documentation of the changes
made to the system, if intervention was necessary
during installation;
• Use of certified material with the CE mark
(305/2011);
• possible instructions relating to the warranty;
• the date and signature of the installation
technician;
NOBIS SRL cannot be held in any way liable in the
event of non-compliance with the installation and
start-up standards of its products.
3.8
PRODUCT UNPACKING
Packaging is composed of boxes in recyclable card-
board according to the RESY standards and wood-
en pallets. All packaging materials can be re-used
for similar use or, if necessary, disposed of as urban
waste, in compliance with legislation in force.
Remove the strap binding the pallet to the packag-
ing and lift the cardboard Fig.1; remove the plastic
bag around the product, ensuring it is intact.
The body must always be moved in a vertical position
using trolleys.
Pay particular attention so that the door and its glass
are protected against mechanical impact which
would compromise their integrity.
If possible, unpack the product near the area where
it will be installed.
To remove the appliance from the pallet, you can
remove the two screws placed under the pallet (13
hex key) to release the appliance from the wooden
base. Fig.2
Position the equipment and proceed with its con-
nection to the chimney flue.
Find, using the 4 adjustment feet, the right level so
that smoke discharge and the pipe are connected
correctly.
10
ENGLISH
Fig.1
Fig.2
Advertisement
Table of Contents
