Table of Contents
Advertisement
Using your Stereo DAB/FM Radio
Let's get started
9. Use the Tune/Select control to choose Alarm On or Off and press to Select. Alarm
Saved is displayed.
10. A bell icon will appear in the standby radio display, together with a '1' or '2' as
appropriate, to confirm that an alarm has been set.
Note: If the time is not set or has failed to update from the radio signal, Time is not set
will be displayed when you try to set the alarm. The radio will then prompt you to set
the time. An alarm can only be set after the time has been set.
Stop the Alarm
When the alarm sounds, short press any button except Snooze to turn off the Alarm,
Alarm off will be displayed. Alternatively, you can short press the Snooze button (see
Snooze function below).
Note: When you press a button to stop the alarm, the alarm symbol will remain in the
display and the alarm will sound again at the same time the next day, unless it was set
for 'Once' only.
Snooze
When the alarm sounds you can Short press the Snooze button. Snooze will be displayed,
followed by the snooze time countdown from 10 minutes, until the alarm sounds again.
Turn off the Alarm
Follow the steps for 'Setting an Alarm' and select 'Off' in step 9. Alternatively you can short
press the Alarm button to turn each Alarm on or off, followed by a short press of the Tune/
Select control to confirm.
Sleep timer
You can set your radio to switch to Standby mode automatically using the sleep timer. You
can choose from Sleep off, 15, 30, 45, 60 and 90 minutes.
32
Using your Stereo DAB/FM Radio with Bluetooth
Using your Stereo DAB/FM Radio
Let's get started
With your radio switched on (not in Standby mode):
1. Long press the Menu button to enter the menu options.
2. Use the Tune/Select control to scroll to <System>. Press to Select.
3. Use the Tune/Select control to scroll to <Sleep>. Press to Select.
4. Use the Tune/Select control to scroll through the available options. Stop when the
sleep time you would like is displayed and press to Select. <Sleep> will be displayed.
5. In the top right of the radio display the number of minutes until your radio will switch
to Standby mode automatically will be displayed e.g. S90.
Cancel the Sleep timer
With your radio switched on (not in Standby mode):
Follow the steps for 'Sleep timer' and select 'Sleep off' in step 4.
Display backlight timeout
You can adjust the display backlight timeout. Options of permanently On, 10, 20, 30,
45, 60, 90, 120, and 180 seconds are available. The current setting will have an '*' in the
display.
With your radio switched on (not in Standby mode):
1. Long press the Menu button to enter the menu options.
2. Use the Tune/Select control to scroll to <System>. Press to Select.
3. Use the Tune/Select control to scroll to <Backlight>. Press to Select.
4. <Timeout> is displayed. Press the Tune/Select control. Use the Tune/Select control to
scroll through the available backlight timeout options of On, 10, 20, 30, 45, 60, 90, 120
or 180 seconds. Stop when the backlight timeout you would like is displayed and press
to Select. <Timeout> will be displayed.
You can now use the Tune/Select control to scroll and Select, as you did to set the
Backlight timeout, to change the settings for the backlight brightness for the <Dim level>
and <On level>. There are 3 options available, High, Medium and Low.
section of these instructions, or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 600 3021.
Using your Stereo DAB/FM Radio with Bluetooth
33
Advertisement
Table of Contents
