Installing The Fork Legs; Removing The Lower Triple Clamp - Husqvarna FE 250 2019 Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.8
12.9
56

Installing the fork legs

402556-10
S02107-11
S02106-10

Removing the lower triple clamp

https://www.motorcycle-manual.com/
Main work
–
Position the fork legs.
1
Bleeder screws are positioned toward the front.
Info
The compression damping is located in left fork
leg COM (white adjusting screw). The rebound
damping is located in right fork leg REB (red adjusting
screw).
Grooves are milled into the side of the upper end of
the fork legs. The second milled groove (from the top)
must be flush with the upper edge of the upper triple
clamp.
–
2
Tighten screws .
Guideline
Screw, top triple
clamp
–
3
Tighten screws .
Guideline
Screw, bottom triple
clamp
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front M8
brake caliper
–
Mount the cable tie(s).
–
Position the brake line, wiring harness, and clamp. Mount and
5
tighten screws .
Finishing work
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
Preparatory work
–
Remove the headlight mask with the headlight. (
–
Raise the motorcycle with a lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
–
Remove front fender. (
–
Remove the handlebar cushion.
M8 17 Nm (12.5 lbf ft)
M8 15 Nm (11.1 lbf ft)
25 Nm (18.4 lbf ft)
Loctite
( p. 98)
p. 109)
p. 111)
p. 109)
p. 53)
( p. 97)
( p. 55)
p. 61)
4
.
® 243™