17.7
Checking the basic position of the shift lever
Info
When driving, the shift lever must not touch the driver's boot when in the basic position.
When the shift lever keeps touching the boot, the transmission will be subject to an excessive load.
17.8
Adjusting the basic position of the shift lever
–
Sit on the vehicle in the riding position and determine the
A
distance
shift lever.
Gap between the shift lever
and the top of the boot
»
If the distance does not meet the specifications:
–
Set the basic position of the shift lever.
400692-10
–
Remove screw
2
lever
.
401950-12
–
Clean gear teeth
–
Mount the shift lever on the shift shaft in the required position
and engage the gearing.
Info
The range of adjustment is limited.
The shift lever must not come into contact with any
other vehicle components during the shift procedure.
–
401951-10
Mount and tighten screw
Guideline
Screw, shift
lever
https://www.motorcycle-manual.com/
TUNING THE ENGINE 17
between the upper edge of your boot and the
10 ... 20 mm (0.39 ...
0.79 in)
1
with the washers and take off shift
A
of the shift lever and shift shaft.
1
with the washers.
M6
14 Nm (10.3 lbf ft)
(
p. 123)
®
Loctite
243™
123