Installing a 2.5-inch hard drive
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Install four black-and-blue M3 mounting screws (two on each side of the drive).
NOTE:
When replacing a drive, transfer the four mounting screws from the old drive to the new drive.
5.
Rotate the drive cage to its upright position
42
Chapter 4 Removal and replacement procedures
(Access panel on page
(Front bezel on page
M3 metric mounting screws can be purchased from HP.
(Preparation for disassembly on page
18).
19).
(Drive cage on page
17).
40).