Speaker - HP EliteDesk 800 G4 SFF Maintenance And Service Manual

Speaker

The speaker is attached to the front of the rotating drive cage.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Rotate the drive cage to its upright position
5. From the inside of the chassis, disconnect the speaker cable from the white system board labeled SPKR
(1).
6. From the outside, front of the chassis, remove the two Torx T15 screws (2) that secure the speaker.
7. Remove the speaker from the computer (2).
To install the speaker, reverse the removal procedures.
60 Chapter 4 Removal and replacement procedures
(Preparation for disassembly on page
(Access panel on page 18).
(Front bezel on page 19).
(Drive cage on page
17).
40).