Table of Contents
Advertisement
3
Insert an anchor, tighten the screw, then
remove the screw to secure the anchor.
4
Insert the screw and tighten it.
Wall mounting adaptor
2
ALC (autoclaved lightweight cellular
concrete)
R Depending on the type of ALC panel, you
may not be able to attach the camera.
Consult the ALC panel manufacturer.
R Do not use the included screws. After
consulting the manufacturer of the ALC
panel, use only commercially-available
metal screw anchors (screw ø4 mm
5
(
/
inches)) designed for ALC panels.
32
R Carefully read the instructions supplied with
the anchors. Follow instructions regarding
drill bit diameter, hole depth, etc.
R Drill a pilot hole. Remove any debris after
drilling the pilot hole.
R Seal the pilot hole with a
commercially-available waterproof sealant.
Other materials (mortar, tile, etc.)
R Do not use the included screws.
R Consult the builder or licensed professional
regarding the type of anchor appropriate for
the installation location and materials.
R Do not install on gypsum board or concrete
blocks.
For assistance, please visit http://shop.panasonic.com/support
HN1007_(en_en)_0308_ver.020.pdf
Installing the front door camera
1
2
2
3
4
27
Attach the wall mounting adaptor to a
porch wall.
R Secure the wall mounting adaptor to
the wall by tightening the 3 supplied
screws (A).
R The spacer can be used to adjust the
installation angle of the camera as
necessary ("Using the spacer",
page 28).
R Do not attach the wall mounting
adaptor at an angle or vertically. (This
will result in the sensors being unable
to correctly make detections.)
Slide the lock key of the interface cover
on the bottom of the camera (B).
Open the interface cover (C).
Slide the power slide switch to ON (D).
1
1
2
3
Setup
1
4
27
2018/03/07
16:48:50
Advertisement
Table of Contents
