Quincy Compressor Climate Control Series Instruction Manual page 6

DANGER !
WARNING !
Climate Control Series
2022209100, August 2018
•Allow ample time for the compressor to cool before performing service pro-
cedures. Some surface temperatures exceed 350°F when the compressor is
operating.
•Do not remove or paint over any DANGER!, WARNING!, CAUTION!, or
instructional materials attached to the compressor. Lack of information re-
garding hazardous conditions can cause property damage or personal injury.
•Periodically check all pressure relief valves for proper operation.
•Do not change the pressure setting of the pressure relief valve, re strict the
function of the pressure relief valve, or replace the pressure relief valve with
a plug.
•Do not install a shutoff valve in the compressor discharge line with out first
installing a pressure relief valve of proper size and design between the shutoff
valve and the compressor.
•All components of the compressed air system must be properly rated for the
application.
•Alterations must not be made to this compressor without Quincy Compres-
sor's approval.
•Be sure that all tools, shipping and installation debris have been re moved
from the compressor and installation site prior to starting the compressor.
•Do not operate the compressor in excess of the ASME pressure vessel rating
for the receiver or the service rating of the compressor, whichever is lower.
•Make a general overall inspection of the unit daily and correct any unsafe
situations. All fasteners and fittings must be kept tight.
•Reckless behavior of any kind involving compressed air is danger ous and
can cause very serious injury to the participants.
•Provisions should be made to have the instruction manual readily available
to the operator and maintenance personnel. If for any reason any part of the
manual becomes illegible or the manual is lost, have it replaced immediately.
The instruction manual should be read periodically to refresh one's memory.
It may prevent a seri ous or fatal accident.
•Wear safety glasses and hearing protection during operation, service and
maintenance procedures.
Air used for breathing or food processing must meet OSHA 29 CFR
1910.134 or FDA 21 CFR 178.3570 regulations. Failure to do so may
cause severe injury or death.
Oil and moisture residue must be drained from the air receiver
daily or after each use. Accumulations of oil residue in the receiver
can be ignited by embers of carbon created by the heat of compres-
sion, causing an explosion, damage to property and injury to per-
sonnel.
4
Quincy Compressor