Vax authorised repair agent prior to continuing use. Please contact our Customer Care • This appliance is not intended for use by persons...
Page 3
Do’s Always make sure the filter and dirt container are fitted Always protect the charger cord from heated surfaces correctly before using your vacuum cleaner. or near open flames. Turn off all controls on the vacuum cleaner before Use only SAA approved 10amp extension cords, disconnecting or connecting to charger.
Page 4
Maintaining your carpets and hard floors will ensure they keep their appearance for longer and Vax will help you take good care of them. Taking care of your Dynamo Power Also inside this guide are instructions on maintaining your new machine, so that it’s always ready...
Contents Let’s talk safety Dynamo Power Included with Getting to know your machine your machine Getting started Docking station Using your machine 2-in-1 tool Taking care of your machine 2-in-1 tool connector Let’s talk technical Charger Accessories What to do if it goes wrong Screw (for attaching handle to vacuum cleaner) Getting in touch...
Charger Specification Accessories & Consumables Name Dynamo Power 25.2V Model No YLS0241A- A300050 Pre-motor filter Model No VX42F Model No VX42 Input voltage 100-240V~50Hz 0.8A Max Battery voltage 25.2V Run time 55 minutes Charge time 5 hours Weight 3.29kg To purchase consumables and Dust bin capacity 0.5l...
Getting started PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE Assembling your 2-in-1 vacuum cleaner Line up floorhead with Line up handle with main Insert screw into back of the main body, push firmly body and lower into place. handle and tighten with a into place.
Using your machine Operating as an upright vacuum cleaner NOTE: Do not use brushbar on hard floors as it may cause damage. Unplug the charger from Place foot on the floorhead and the mains and remove pull the handle backwards to the vacuum from the recline the machine.
Page 9
Using your machine Operating as a handheld vacuum cleaner Press the handheld release Press the On/Off button to button. Lift to remove the switch the handheld on. handheld from the main body. For a more detailed clean, line up and push the 2-in-1 connector into the handheld nozzle, then push and attach the 2-in-1 tool securely onto the connector.
Taking care of your machine Emptying the dirt container CAUTION: Always switch off the vacuum cleaner before carrying out any maintenance or troubleshooting. Press the handheld release Press the dirt container release button. Lift to remove the button to remove the dirt container. handheld from the main body.
Taking care of your machine Cleaning the filter CAUTION: Always switch off the vacuum cleaner before carrying out any maintenance or troubleshooting. Do not use your vacuum cleaner without the filters in place. Press the handheld release Press the dirt container Squeeze tabs to remove filter, button.
• Do not replace the battery with a battery of a different type. • If it becomes necessary to replace the battery, contact the Vax Careline on AU: 1300 361 505 / NZ: 0800 800 900 to determine the location of your nearest authorised service agent.
Push the other side of the brushbar back into the floorhead and refit the floorhead cover. Don’t forget your accessories! AU: www.vax.com.au / NZ: www.vax.co.nz Pre-motor filter Model No. VX42F...
What to do if it goes wrong Problem Solution • Check the machine is fully charged. Go to ‘Using your machine’. • Check the charger is plugged into the mains and correctly connected to the docking station. Go to ‘Getting started’. Why does my vacuum •...
Page 15
Getting in touch * Calls are charged at the standard local rate. Please make a note of the serial number and model number of the vacuum cleaner before calling.
Need help?
Do you have a question about the VX42 and is the answer not in the manual?
Questions and answers