Kranzle quadro 11/140 TST Operating Manual page 10

Functional details
High pressure hose and spray device
The high pressure hose and spray device which are part of small quadro series
equipment, are made of high quality material and engineered to conform with
the operating conditions of the high pressure cleaner and are duly labeled.
If replacement parts are required, only such parts that are authorized
by the manufacturer may be used. The warranty is automatically void
if spare parts of third-party providers are used! The high pressure hose
and spray device must be connected in a pressure-tight manner
(without leakage).
The high pressure hose may not be driven over, pulled excessively, or
twisted. The high pressure hose may under no circumstances be pulled
over sharp edges. Defective high pressure hoses must not be repaired
(acc. to DIN 20022) but have to be replaced by new hoses approved by
the manufacturer.
Prior to putting the high pressure cleaner into operation make sure
that all safety instructions be observed.
18
Putting into operation
It is imperative that safety instructions be observed during
use of the high pressure cleaner.
Neither set up or operate the small quadro series in rooms where there
is a risk of fire or explosion nor put it into puddles. Do not use the high
pressure cleaner under water. If, none the less, the high pressure
cleaner is operated in a hazardous area, the applicable safety
regulations are to be observed.
1. For moving the high pressure cleaner
to the place of use, please release
locking break.
2. The small quadro series is a movable
high pressure cleaner with sturdy trol-
leys ideally suited for difficult terrain.
For steering the high pressure cleaner
put the foot against the tipping
support and then pull the device
towards you.
19