Creosote (Chimney) Cleaning - Heat & Glo EXCLAIM-36 Owner's Manual

B. Creosote (Chimney) Cleaning
Frequency:
As needed; at least annually before light-
ing, or once every two months during heating season.
When creosote has accumulated it shall be removed
to reduce the risk of a chimney fire.
By:
Chimney Sweep
Tools Needed: Brush, Phillips screwdriver
• When wood is burned slowly, it produces tar and
other organic vapors, which combine with expelled
moisture to form creosote. The creosote vapors
condense in the relatively cool chimney flue of a
slow-burnign fire. As a result, creosote residue
accumulates on the flue lining. When ignited, this
creosote makes an extremely hot fire.
• Remove all ash from the firebox and extinguish all
hot embers before disposal. Allow the fireplace to
cool completely.
• Remove the top of the termination cap as shown in
Figure 4.1 to clean the cap and chimney.
• The creosote or soot should be removed from the
chimney with a brush specifically designed for the
size of chimney in use.
• Reinstall termination cap.
• Clean out fallen debris from the firebox.
WARNING! Risk of Fire!
HOT. Prevent creosote buildup.
Remove screws,
lift top cover.
Top Cover
Cap
Chimney
TR11/TR11T
TR444/TR442
Round Termination Cap
Figure 4.1 Chimney & Termination Cap Cleaning
Ignited creosote is extremely
Remove 4 screws
and lift top pan off.
Cap
Slip
Section
ST1175
ST475
Square Termination Cap
Heat & Glo • Exclaim-36/42 Owner's Manual • 4013-267 • Rev S • 03/23
Remove 2 screws from
the front and back and
lift the top off.
SCREW
TCT1175
Terra Cotta
Termination Cap
Available US only
1. REMOVE (8) SCREWS
2. LIFT TOP
TOP
TOP
SCREW
DT SERIES
15