Related Manuals for Atlas Filtri OASIS DP RO
Summary of Contents for Atlas Filtri OASIS DP RO
- Page 1 OASIS DP Reverse Osmosis Units with Made in Italy components INSTRUCTIONS FOR INSTALLATION...
-
Page 2: General Information
OASIS DP - Reverse Osmosis Units INSTALLATION, USE AND MAINTENANCE MANUAL Dear Costumer, thanks for choosing this Atlas Filtri product. 1. GENERAL INFORMATION The indications in this manual apply to models: OASIS DP STD OASIS DP PUMP OASIS DP is a device intended to process drinking water able to modify its organoleptic and chemical properties, reducing the saline content while guaranteeing microbiological safety. -
Page 3: Installation
The manufacturer cannot be held liable for any damages caused by improper use, by failure to observe what indicated in this manual, by repairs not performed by professionally qualified personnel or due to changes and alterations to the original device functions. OASIS DP RO... - Page 4 Oasis DP RO operation explained Reverse osmosis is by far the most advanced water purification technology in use today. A special semipermeable membrane structure similar in its properties to the membrane of a living cell is capable of purifying drinking water from virtually all harmful impurities. The membrane can be thought of as having tiny pores, 200 times smaller than viruses and 4000 times smaller than bacteria.
- Page 5 Permeate Connect to tap Water Flow though Atlas Filtri Oasis RO Unit. Raw water enters the RHS of the triple pre-filter housing under the mounting plate; labeled, FEED WATER IN After Passing through the pre-filters, water exits from the LHS and is piped to a square white block behind the top horizontal filter housings.
- Page 6 Max. feed water TDS mg/l (ppm) 1000 1000 Max. feed water temperature °C Min. feed flow Min. feed pressure Max. feed pressure Electric power Rated voltage Frequency Absorbed current Power Power type Direct current Rated voltage Head OASIS DP RO...
- Page 7 Unscrew the cold water hose nut from the wall coupling. 1/2” With sealing tape (PTFE), install the 1/2" MF water intake Wall with the 1/4" tap. coupling Reassemble the previously detached hose on the water intake male. Connect the OASIS 1/4" hose to the water intake. OASIS DP RO...
- Page 8 Tighten the fastening nut and install the check valve with the arrow facing the bracket, as close to the drain as possible. Drain pipe Quick coupling Drain bracket Gasket Bolt Bolt lock nut Sink drain siphon pipe Ø 8 mm OASIS DP RO...
- Page 9 1/4" permeated pipe 2.5.5 membrane and filter cartridge installation To install the membrane, see paragraph 3.2: "Membrane replacement". To install the filter cartridge, see paragraph 3.3: "Filter cartridge replacement". WARNING: using cartridges other than original ones voids the warranty. OASIS DP RO...
-
Page 10: Routine Maintenance
Before performing any maintenance, make sure the power cord is unplugged. To clean the device, do not use corrosive or acidic products or steel wool or steel brushes. Do not clean the device with direct jets of water or at high pressure. OASIS DP RO... - Page 11 Original cartridges are available in practical and convenient KITS. OASIS DP models - OASIS DP cartridge KIT - 1. SEDIMENT - PP melt blown filter 5 micron 2. CTO Chlorine-Taste-Odor carbon G.A.C. 3. VOC Volatile-Organic-Compound carbon block filter 5 micron Replacement pre-filter kit PN 807276 OASIS DP RO...
-
Page 12: Non-Routine Maintenance
Perform the replacement steps as in the procedure described in point 3.4. NON-ROUTINE MAINTENANCE ➥ Non-routine maintenance (repairs and/or replacement of non consumable parts) must be performed by personnel qualified by the manufacturer and accredited distributors, or the warranty is void. DATE WORK TYPE OASIS DP RO... -
Page 13: Troubleshooting
Replace the pump AC/DC adaptor (see section 4 non-routine maintenance). Problem: With dedeicated (processed water) tap turned-off, the booster pump restarts for several seconds. Cause Solution Hydraulic circuit leak. Check the hydraulic circuit to the drain tap and look for leaks. OASIS DP RO... -
Page 14: Supply Water Quality Requirements
** If your home is supplied with raw wellwater, perform laboratory test of your water before installing a reverse osmo- sis filter. If any of your water indices exceed the limit, consider using a water treatment system to correct supply water quality. Refer to water treatment specialists or companies for advice and proper equipment selection. OASIS DP RO... - Page 15 * Values are determined under the following conditions: temperature of supply water is 25 °C (77 °F), supply water quality and operation conditions correspond to manufacturer’s requirements. Replacement Carbon Post Filter PN 807278 Replacement Remineralising Cartridge PN 807279 OASIS DP RO...
- Page 16 ATLAS FILTRI and SANIC are registered trade marks of ATLAS FILTRI S.r.l. Unauthorized use of the registered trade marks is strictly forbidden and legally persecuted. Images and texts are property of ATLAS FILTRI S.r.l., which reserves the rights to change products design and specification without prior notice.