Operation - Black & Decker BEPW1600HTH Manual

Attaching Spray Handle (Fig. A)
To connect the spray handle ( 4 ) to the spray wand ( 2 ),
u
insert the end of the spray handle onto the end of the
spray wand.
Press in and turn the spray handle counterclockwise to
u
lock it into position.
Attaching High Pressure Hose (Fig. B)
Notice: Never pull high pressure hose or water supply hose
to move pressure washer. This could damage hose and/or
pump inlet and/or pump outlet.
To connect the high pressure hose ( 1 ) to the
u
spray handle ( 4 ), depress the hose connect button ( 22 )
while clicking the hose end ( 24 ) into the spray handle.
Release the hose connect button when the hose end has
clicked into position.
To connect the high pressure hose to the pressure washer
u
unit ( 8 ), screw the hose collar ( 25 ) onto the high pres-
sure water outlet ( 13 ).
Note: Uncoil the high pressure hose before installation to
prevent kinks.
Note: Avoid cross threading when installing the hose. Cross
threading will cause leaks.
Attaching Garden Hose (Fig. C)
Note: Before connecting the garden hose to the pressure
washer unit, run water through the garden hose for thirty
seconds to clear any debris from inside the garden hose.
To connect the garden hose to the pressure washer
u
unit ( 8 ), screw the filter ( 21 ) to the water intake ( 12 ).
Connect the garden hose to the hose connector ( 20 ) by
u
loosening the screw of the garden connector and attach-
ing the hose onto the connector.
Attach the garden hose ( 26 ) mounted onto the garden
u
connector to the filter ( 21 ) until it "clicks".
Note: Always disconnect the garden hose after usage.
Attaching Nozzles (Fig. D)
Danger! Risk of fluid injection. Do not direct discharge
stream toward persons, unprotected skin, eyes or any pets or
animals. Serious injury will occur.
Warning! Flying objects could cause risk of serious injury. DO
NOT attempt to change nozzles while pressure washer is run-
ning. Turn pressure washer unit OFF before changing nozzles.
To connect a nozzle to the spray wand ( 2 ) , depress
u
the nozzle button ( 3 ) on the spray wand and insert the
appropriate nozzle.
Release the button to lock the nozzle in place.
u
Give the nozzle a firm tug to ensure the nozzle is locked
u
into place.
Note: 360° angled nozzle just fits to the short spray gun not to
the standard spray handle.
(Original instructions)
Spray Fan to Pencil Jet Nozzle
Adjusting Fan Pattern (Fig. E1)
The angle of spray coming out of the spray wand may be
adjusted by rotating the nozzle. This will vary the spray pattern
from approximately a 0 ° narrow high impact stream to a 60 °
wide fan spray.
A wide fan pattern distributes the impact of the water over
a larger area, resulting in excellent cleaning action with a
reduced risk of surface damage. Large surface areas can be
cleaned more quickly using a wide fan pattern.
A narrow pencil jet stream distributes the impact of the water
in a concentrated area, resulting in a high impact force on
the cleaning surface. Use a narrow pencil jet stream for deep
cleaning in a concentrated area. However, use it cautiously, as
it may damage some surfaces.
Attaching Soap Bottle (Fig. J4)
To connect the soap bottle ( 16 ) to the spray handle ( 4 ),
insert the end of the soap bottle inside the spray handle and
turn the soap bottle counterclockwise to lock it into position.
Note: The wand and soap bottle cannot be installed at the
same time.
Note:The soap bottle should be positioned underneath the
barrel of the spray handle. Do not position the soap bottle
above the barrel of the plastic gun as this will lead to soap
dripping on the barrel.
Spray Tip
Spray fan to pencil jet
nozzle
Turbo Nozzle

Operation

Warning! To reduce the risk of serious personal injury, turn
unit off and disconnect it from power source before making
any adjustments or removing/installing attachments or acces-
sories. An accidental start-up can cause injury.
Proper Hand Position (Fig. F)
Warning! To reduce the risk of serious personal injury, always
use proper hand position as shown.
Warning! To reduce the risk of serious personal injury, always
hold securely in anticipation of a sudden reaction.
Proper hand position requires one hand on the spray handle
grip ( 5 ) and the other hand on the spray handle ( 4 ) .
Pressure Washing
Preparing Surface for Cleaning
Remove objects from the area which could create a
u
hazard such as children's toys or outdoor furniture.
ENGLISH
Application
For gentle wide area cleaning.
For abrasive cleaning.
9