Table of Contents
Advertisement
DISPLAYED MESSAGE
Insert water spout
Insert milk container
Insert infuser assembly
Water circuit empty
press ok to start
filling process
Press ok to start
cleaning process
or turn milk froth
adjustment dial
Turn dial to
position to
CLEAN
start cleaning
Turn the milk froth
adjustment dial to
milk position
Descaling needed press
ok to start (~45min)
Replace water filter
press
to start
OK
ALERTS
POSSIBLE CAUSE
The hot water
spout is not inserted
or is not inserted
correctly.
The milk container
is not inserted
correctly.
The infuser has
not been replaced
after cleaning.
The water circuit
is empty.
The milk container
has been inserted
with the froth
adjustment dial in
the
position.
CLEAN
Milk has been
delivered recently
and the tubes
inside the milk
container must
be cleaned.
The milk container
has been inserted
with the froth
adjustment dial in
the
position.
CLEAN
The machine must
be descaled.
The water softener
filter is exhausted.
WHAT TO DO
Insert the water spout as far as
it will go.
Insert the milk container as far as
it will go.
Insert the infuser as described in section
'Cleaning the infuser'.
Press
to deliver water from the spout
OK
until it flows out normally. Delivery stops
automatically.
If the problem persists, make sure
the water tank is fully inserted.
To proceed with the
press
or turn the froth adjustment
OK
dial to one of the milk positions.
Turn the froth adjustment dial
to
.
CLEAN
Turn the dial to the required
froth position.
Press
to start descaling or
OK
to descale later. The descaling procedure
described in section 'Descaling' needs to
be performed.
Press
to replace or remove
OK
the filter, or
to carry out the
BACK
procedure later. Follow the instructions
in section 'Water filter'.
function,
CLEAN
BACK
51
Advertisement
Table of Contents
