Advertisement
Network-M2 Card Installation and Configuration
Figure 7. EMP Sensor Discovered
N N e e t t w w o o r r k k - - M M 2 2 C C a a r r d d I I n n s s t t a a l l l l a a t t i i o o n n a a n n d d C C o o n n f f i i g g u u r r a a t t i i o o n n
For instructions on installing and configuring a Network-M2 card, refer to the document
PredictPulse™ Setup for an Eaton® Gigabit Network (Network-M2)
I I n n s s t t a a l l l l i i n n g g a a n n d d C C o o n n n n e e c c t t i i n n g g t t h h e e S S i i e e r r r r a a W W i i r r e e l l e e s s s s L L X X 4 4 0 0 L L T T E E R R o o u u t t e e r r
Refer to the Quick Start Guide provided with the Sierra Wireless LX40 LTE router for additional instructions on
mounting the router and connecting power.
NOTE
To install the Sierra Wireless LX40 LTE router:
1.
Unpack the shipping carton and ensure it contains (see
•
One Sierra Wireless LX40 router
•
One AC adapter
•
One antenna
•
One CAT6 cable
2.
Install the router in a suitable location.
NOTE
6
Connecting a Sierra Wireless LX40 Router to an Eaton Network Card
The router must be powered by a 120V electrical outlet powered by the UPS. This
ensures that the router is protected during a power outage. If no UPS-protected outlet is
available, a Universal Accessory Power (UAP) kit is required. The UAP must be installed
by an Eaton technician. Contact your Eaton service representative for a quote.
If the double-sided tape provided with the EMP is not used to attach the EMP, it may be
used to secure the Sierra Wireless LX40 LTE router (see
Environmental Monitoring Probe (EMP) Gen 2
Card.
Figure
8):
Installation).
P-164001160—Rev 01
Advertisement
