Sierra Wireless LX40 Connecting Manual page 3

Connecting lte router to an eaton network card

Hide thumbs Also See for LX40:

12. The INDGW-M2 or INDGW-X2 card home page displays (see

13. The green ON LED should be flashing to indicate that the card is operating normally (see

Figure

If the green ON LED is not flashing, the INDGW-M2 or INDGW-X2 card may need to be reset. Remove the card

to reset it, wait 10 seconds, plug it back in, and wait 3 minutes. If the LED still does not flash, contact the

Brightlayer Data Center at 800-356-5737, option 2, option 2 to troubleshoot.

Figure 3. INDGW-M2 or INDGW-X2 Home Page

I I N N D D G G W W - - M M 2 2 o o r r I I N N D D G G W W - - X X 2 2 C C a a r r d d F F i i r r m m w w a a r r e e U U p p d d a a t t e e

As noted in the

firmware installed on the INDGW-M2 or INDGW-X2 card, click the Maintenance (wrench) icon on the card

home page (see

The Version column shows the firmware version of the card. To check the latest firmware for the network

card:

•

For an INDGW-M2 card, go to

https://www.eaton.com/us/en-us/catalog/backup-power-ups-surge-it-power-distribution/eaton-

industrial-gateway-card.html

•

For an INDGW-X2 card, go to

https://www.eaton.com/us/en-us/catalog/backup-power-ups-surge-it-power-distribution/eaton-gigabit-

industrial-gateway-card.html

Click Resources, then scroll down and expand the Software, firmware, and applications section.

2).

Prerequisites

section, the installation requires the latest card firmware. To view the

Figure

3). The Firmware tab shown in

Connecting a Sierra Wireless LX40 Router to an Eaton Network Card

INDGW-M2 or INDGW-X2 Card Installation

Figure

3).

Figure 4

displays.

P-164001160—Rev 01

Figure 1