Advertisement
Figure 5. EMP MODBUS ADDRESS Switches
3.
Connect the USB end of the cable to the AUX port on the INDGW-M2 or INDGW-X2 card and the RJ45
end to the FROM DEVICE port on the EMP. If possible, route the cable into the battery cabinet and place
the EMP in the battery cabinet.
4.
On the INDGW-M2 or INDGW-X2 home page (see
to display the SENSOR COMMISSIONING page (see
Figure 6. Sensor Commissioning Page
5.
As shown in
Figure
6, no sensors have yet been discovered in the system. Click Discover to identify the
EMP sensor(s). When discovered, the EMP is displayed as shown in
•
If no device is found, verify the EMP connections and settings and click Discover again.
Connecting a Sierra Wireless LX40 Router to an Eaton Network Card
INDGW-M2 or INDGW-X2 Card Installation
Figure
3), select Environment from the left-hand menu
Figure
6).
Figure
7.
P-164001160—Rev 01
5
Advertisement
