Related Manuals for Kärcher K 2 Ergo
Summary of Contents for Kärcher K 2 Ergo
- Page 1 K 2 Ergo OPERATOR MANUAL High-Pressure Washer ..2 MANUEL D’UTILISATION Nettoyeur haute pression ..16 MANUAL DE USUARIO Limpiador de alta presión ..32...
-
Page 2: Table Of Contents
HIGH-PRESSURE WASHER OPERATOR MANUAL Model Overview Owner/User Responsibility Important Safety Instructions The owner and/or user must have an un- Assembly Instructions derstanding of the manufacturer’s oper- ating instructions and warnings before Operating Instructions using this pressure washer. Using the Accessories Warning information should be empha- Working with Detergents sized and understood. -
Page 3: Model Overview
MODEL OVERVIEW 1 Quick connect high-pressure outlet 13 Power cord with Ground Fault Circuit 2 High-pressure outlet Interrupter (GFCI) 3 ON/OFF switch 14 Wheels 4 Hose/Cord Hook 15 Trigger gun 5 Handle 16 Trigger gun safety lock 6 Collapsable transport handle 17 Key to disconnect the high-pressure 7 Spray Wand Storage hose from the trigger gun... -
Page 4: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS WARNING physical injuries to the operator and When using this product basic precau- irreversible damage to the machine. tions should always be followed, includ- WARNING – Risk of Electrocu- ing the following: tion Read all the instructions before using Inspect cord before using –... - Page 5 TURE AND INJURY, DO NOT WATER SUPPLY OPERATE THIS PUMP WITH COM- (Cold Water Only) PONENTS RATED LESS THAN 1600 CAUTION PSI WORKING PRESSURE (INCLUD- When connecting the water inlet to the ING BUT NOT LIMITED TO SPRAY water supply mains, local regulations of GUNS, HOSE AND HOSE CONNEC- TIONS).
-
Page 6: Assembly Instructions
STEP 5: ASSEMBLY INSTRUCTIONS Pull out the locking slide of the trigger – gun handle. Assembly Insert the small end of the high-pres- – STEP 1: sure hose into place. Insert wheels into the body of the Push the locking slide back into the –... - Page 7 the spring tension and twist into locked position. Note: The actual appearance of the GFCI may be different from this illustration. STEP 3: 1 Screw the supplied garden hose con- STEP 6: nector on to the end of your garden Unlock the trigger gun safety lock.
-
Page 8: Using The Accessories
USING THE ACCESSORIES WORKING WITH DETERGENTS WARNING To avoid serious injury never point spray For best results see Cleaning Tips for nozzle at yourself, other persons or ani- specific information on how to clean mals. different surfaces. CAUTION Always Use Kärcher ®... -
Page 9: Taking A Break
STEP 2: SHUTTING DOWN & Fill a container with Kärcher deter- CLEAN-UP gent. Place the filter end of detergent siphon tube into the container. STEP 1: Turn the switch to OFF (0) position and unplug cord from outlet. STEP 3: ... -
Page 10: Winterizing And Long-Term Storage
CAUTION CARE AND MAINTENANCE When disconnecting the supply or high- INSTRUCTIONS pressure hose, warm water may leak from the connector after operation. Cleaning the water inlet filter STEP 6: Push the housing of the quick con- STEP 1: nect toward the rear and disconnect Disconect the connector from the the high-pressure hose from the unit. -
Page 11: Cleaning Tips
CLEANING TIPS House Siding CAUTION (with or without detergent). Pre-rinse Before cleaning any surface an in- cleaning surface with fresh water. If us- conspicuous area should be cleaned ing detergent, apply to surface at low to test spray pattern and distance for pressure (for best results, limit your maximum cleaning results. -
Page 12: Optional Cleaning Accessories
gent to dry on surface. If needed, use OPTIONAL CLEANING special wash brush attachment (not in- ACCESSORIES cluded) to remove stubborn dirt. Rinse at high-pressure in a sweeping motion Optional accessories are available to keeping the spray nozzle approximately further enhance your cleaning capabili- 15-20 cm (6-8 in.) from the cleaning sur- ties. - Page 13 Rotating Wash Brush (bayonet) Wet Sandblasting Kit (bayonet) For more effortless cleaning of all Why spend hours stripping old paint and smooth surfaces (painted, glass and rust by hand using harsh chemicals? Let plastic) try the Kärcher ® Rotating Wash the Kärcher ®...
-
Page 14: Troubleshooting
TROUBLESHOOTING WARNING Disconnect the unit from the power source before making any repair. Issue Cause Solution Motor will not start On/Off switch is in the “OFF” Turn switch to the “ON” (I) (0) position. position Power cord is not plugged in. Plug in power cord. Electrical outlet does not Try a different outlet. - Page 15 Issue Cause Solution No detergent. Detergent is too thick. Dilute detergent, for best results use Kärcher detergent. Filter on detergent siphon tube Run warm water through filter is clogged. to remove debris. Damaged or clogged detergent Remove obstruction or replace siphon tube.