Advertisement
FORM YRK2-N1
ISSUE DATE: 03/18/2019
7. Layout the curb pieces as shown at the end of the
previous section.
8. Install the 3/8" bolts on both ends of End Pan-
els (F) and Supply Panel (J) through the desig-
nated holes on Side Panels (E) and End Panels
(F). Make sure the corners are flush and square
as shown in Figure 4.
Place the curb in the proper location.
Make sure the curb section is "IN
SQUARE."
9. Layout the curb pieces as shown at the end of the
previous section.
10. Install the 3/8" bolts on both ends of End Panel (H)
through the designated holes on Side Panel Right
(A) and Side Panel Left (B). Make sure the cor-
ners are flush and square as shown on Figure 5.
Place the curb in the proper location.
Make sure the curb section is "IN
SQUARE."
11. Install Support Rails (K) on the Side Panels (A)
and (B). Attach the Support Rails (K) in place
with .25-14 x 1" screws as shown in Figure 5.
12. Install Support Rails (K) on the Side Panels (C)
and (D). Attach the Support Rails (K) in place
with .25 -14 x 1" screws as shown in Figure 5
Each section of the curb is to be connect-
ed with the provided splice channels as
shown in illustrations.
YORK
F
J
E
FIGURE 4 -
M (4 TYP)
D
K
C
FIGURE 5 -
E
SUPPLY OPENING
43 X 71.61
F
LD08552
K
K
K
H
A
LD085553
B
3
Advertisement
