Honeywell Prestige 2.0 THX9421 Manual page 69

Mounting C7189U1005 Wired Indoor
Sensor
Use the following steps to mount the sensor:
1. Remove the cover from the remote sensor (see Fig.
71).
Fig. 71. Remove the cover.
2. Pull wires through wire hole.
3. Position wallplate on wall, level and mark screw hole
positions with pencil.
4. Drill holes at marked positions, then tap in supplied
wall anchors.
THX9321 PRESTIGE
5. Place wallplate over anchors, insert and tighten
6. Replace the cover on the remote sensor.
Mounting Entry/Exit Remote or Vent
M24056
Boost Remote
Mounting the remote is optional.
1. Remove the front cover from the remote.
2. Use provided screws and wall anchors to fasten the
Fig. 73. Mounting Entry/Exit Remote or Vent Boost
3. Replace the cover on the remote.
69
®
2.0 AND THX9421 PRESTIGE
mounting screws (see Fig. 72).
Fig. 72. Mount wallplate to wall.
remote to the wall. Drill 3/16-inch holes for drywall,
7/32-inch for plaster.
Remote.
®
IAQ WITH EIM
M24057
M33095
68-0311—07