Honeywell Prestige 2.0 THX9421 Manual page 49

ISU Installer Setup
Number Name
0 to 30 minutes (in 5 minute
6030 Remote Setback
increments)
Time Delay from
Occupied to
Unoccupied
72° F to 90° F
6040 Remote Setback -
Standby Cool
Setpoint
50° F to 70° F
6040 Remote Setback -
Standby Heat
Setpoint
None
6050 What Terminals are
Wired to the Full S1
Drain Pan Alert Dry
S2
Contact?
S3
S4
Normally Open
6060 Full Drain Pan Alert
Dry Contact Setup Normally Closed
THX9321 PRESTIGE
Table 4. Installer Setup (ISU) Table. (Continued)
Settings Default
0 minutes
85° F
64° F
None
Normally Open
49
®
2.0 AND THX9421 PRESTIGE
Residential,
Commercial Requires
or Both EIM
Commercial Yes Remote Setback requires an EIM (Equipment
Interface Module).
The Remote Setback Time Delay forces the
thermostat to wait before it switches from
Occupied to Standby temperature settings.
When set to 0 minutes, the thermostat will
switch from Occupied to Standby temperature
settings immediately when the room is
unoccupied.
Commercial Yes Remote Setback requires an EIM (Equipment
Interface Module).
During occupied periods, the occupancy sensor
tells the thermostat to go to STANDBY (setback
settings) when no one is in the room. If
someone is in the room, then it follows the
settings of the occupied period. The occupancy
sensor is ignored during unoccupied periods.
If the thermostat is setup for non-
programmable, the occupancy sensor tells the
thermostat to go to STANDBY settings when no
one is in the room. If someone is in the room,
then it follows the settings set by the user.
Commercial Yes Remote Setback requires an EIM (Equipment
Interface Module).
During occupied periods, the occupancy sensor
tells the thermostat to go to STANDBY (setback
settings) when no one is in the room. If
someone is in the room, then it follows the
settings of the occupied period. The occupancy
sensor is ignored during unoccupied periods.
If the thermostat is setup for non-
programmable, the occupancy sensor tells the
thermostat to go to STANDBY settings when no
one is in the room. If someone is in the room,
then it follows the settings set by the user.
Both Yes Dry Contact Alerts require an EIM (Equipment
Interface Module).
Both Yes Dry Contact Alerts require an EIM (Equipment
Interface Module).
Choose an option appropriate for the type of
device installed.
Normally Open: The Dry Contact device is
normally open and will close when the device
detects the drain pan is full.
Normally Closed: The Dry Contact device is
normally closed and will open when the device
detects the drain pan is full.
®
IAQ WITH EIM
Notes
68-0311—07