Checking The Rubber Grip - Husqvarna TC 125 2019 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.42
74
K01282-10

Checking the rubber grip

401197-01
M01455-10
Main work
–
Check the throttle cable routing.
The throttle cable must be routed along the back of the
handlebar, to the right of the frame, above the fuel tank
bracket, and to the carburetor. The throttle cable must be
secured behind the fuel tank contact area rubber band.
» If the throttle cable is not routed as specified:
–
Correct the throttle cable routing.
Finishing work
–
Install the fuel tank. (
–
Install the right side cover. (
–
Mount the seat. ( p. 60)
–
Install the air filter box cover. (
–
Check the rubber grips on the handlebar for damage, wear,
and looseness.
Info
The rubber grips are vulcanized onto a sleeve on the
left and onto the handle tube of the throttle grip on the
right. The left sleeve is clamped onto the handlebar.
The rubber grip can only be replaced with the sleeve
or the throttle tube.
» If a rubber grip is damaged or worn
–
Change the rubber grip.
–
1
Check that screw is firmly seated.
Guideline
Screw, fixed M4
grip
A
Diamond must be located at the top.
p. 66)
p. 65)
p. 60)
5 Nm (3.7 lbf ft)
®
Loctite 243™