Stopping - Husqvarna PP 480 HF Operator's Manual

• Set the required drive mode depending on if the power
unit will be used for wall sawing or wire cutting. (DRIVE
CHOICES>SET DRIVE CHOICES)
>>DRIVE CHOICES
SET GEAR
[GEAR 1]
SET DRIVE MODE
[BLADE]
SET ROT. DIR.
[STANDARD]
SET FUSE
[32A]
• Select the required direction of rotation. The direction of
rotation can only be altered when the blade/wire is not
moving. (DRIVE CHOICES>SET ROT. DIR.)
>>DRIVE CHOICES
SET GEAR
[GEAR 1]
SET DRIVE MODE
[BLADE]
SET ROT. DIR.
[STANDARD]
SET FUSE
[32A]
• State which fuse the power unit is connected to. (DRIVE
CHOICES>SET FUSE)
>>DRIVE CHOICES
SET GEAR
[GEAR 1]
SET DRIVE MODE
[BLADE]
SET ROT. DIR.
[STANDARD]
SET FUSE
[32A]
• Start the rotation of the blade/wire by holding the "back"
button in while turning the rotation control clockwise.
ON/OFF
If the water valve is set to "AUTO" there is a 3 second
delay before the blade rotation begins. The delay is to cool
down the power pack which can get hot when active and
no cooling water is circulating.
The water flow is adjusted with the ball valve at the
incoming water connector on the power pack.
STARTING AND STOPPING
20 DEC 20:55
20 DEC 20:55
20 DEC 20:55
OK
0

Stopping

• To switch off the blade rotation, turn the blade rotation
control anti-clockwise back to its zero position.
ON/OFF
• The water coolant is turned off automatically with a 3 sec
delay. Applies only if the water valve is set to "AUTO".
• Turn off the remote control by pressing the "ON/OFF"
button.
ON/OFF
• Turn the main switch on the power pack to "0"-position.
OK
0
OK
0
– 15
English