Basic Working Techniques; Transport And Storage - Husqvarna PP 480 HF Operator's Manual

• Check that all couplings, connections and cables are
intact and free from dirt.
• Check that all cables and the water supply are correctly
connected to the machine before starting it.
• Never pull out the power cable without first switching off
the power pack and waiting for the engine to come to a
complete halt. If an emergency situation should arise
anyway, push the red emergency stop button on the power
pack or the stop button on the remote control.
• Keep all parts in good working order and ensure that all
fixtures are properly tightened.

Basic working techniques

The following can be operated using the control levers on the
remote control:
• Travel feed
ON/OFF
• Arm feeding
ON/OFF
• Blade/wire rotation Start the rotation of the blade/wire by
holding the "back" button in while turning the rotation
control clockwise. The rotation speed is controlled with a
potentiometer.
ON/OFF
• Read through the manual supplied with the wall saw for
further instructions in sawing technique. See the supplied
DVD for working technique tips.
OPERATING
OK
0
OK
0
OK
0

Transport and storage

• Always switch of the power pack and pull out the electric
cable before moving the equipment.
• Use the cases provided to store the equipment.
• Secure the equipment during transportation in order to
avoid transport damage and accidents.
• Store the equipment in a lockable area so that it is out of
reach of children and unauthorized persons.
• Store the machine and its equipment in a dry and frost
proof place.
• Do not expose the machine to temperatures exceeding
45°C or to direct sunlight.
– 11
English