Axis Q8685-E User Manual page 20

AXIS Q8685–E PTZ Network Camera
Setup
10. Click OK.
How to record video when the camera detects impact
Shock detection allows the camera to detect tampering caused by vibrations or shock. Vibrations due to the environment or to an
object can trigger an action depending on the shock sensitivity range, which can be set from 0 to 100. In this scenario, someone is
throwing rocks at the camera after hours and you would like to get a video clip of the event.
1. Go to Settings > System > Detectors.
2. Set shock detection to on, and set a value for the shock sensitivity.
Create an action rule:
3. Go to Settings > System > Events and add an action rule.
4. Type a name for the action rule.
5. From the list of triggers, select Detectors and then select Shock detection.
6. From the list of schedules, select After Hours.
7. From the list of actions, select Send Video Clip.
8. Select an existing stream profile or create a new one.
9. Enable and set the pre-trigger time to 5 seconds.
10. Enable While the rule is active.
11. Enable and set the post-trigger time to 60 seconds.
12. Select an existing recipient or create a new one.
13. Click OK.
How to direct the camera and open the lock to a gate when someone is nearby
This example explains how to direct the camera and open a gate when someone wants to enter during daytime. This is done by
connecting a PIR detector to the product's input port and a switch relay to the product's output port.
Required hardware
• Mounted PIR detector
• Switch relay connected to the gate lock, in this case the switch is normally closed (NC)
• Connecting wires
Physical connection
1. Connect the wires from the PIR detector to the input pin, see I/O connector on page 26.
2. Connect the wires from the switch to the output pin, see I/O connector on page 26
Configure I/O ports
You need to connect the switch relay to the camera from the camera's webpage. First, configure the I/O ports:
Set the PIR detector to an input port
1. Go to System > I/O ports.
20