Page 2
Remove the following in accordance with the factory service manual: Air Cleaner Assembly RHS Mud Flap RHS Guard Liner Remove and discard Air Deflector Remove and discard Copyright Safari 4x4 Engineering Pty Ltd Melbourne Victoria Australia – www.safari4x4.com.au Page 2 of 8...
Page 3
Hint: Place masking tape over the join between the flare and guard panel prior to drilling to prevent any swarf from Step Drill 16mm Dia entering the join. Copyright Safari 4x4 Engineering Pty Ltd Melbourne Victoria Australia – www.safari4x4.com.au Page 3 of 8...
Page 4
(Item 3) onto the A- pillar and align the bracket with the marked bracket outline. Mark the three mounting hole positions with a felt tip pen. Align Copyright Safari 4x4 Engineering Pty Ltd Melbourne Victoria Australia – www.safari4x4.com.au Page 4 of 8...
Page 5
(Item 3) to the A-pillar with three self-tapping screws (Item 5). Self-Tapping Screws Remove Remove and discard the air and discard intake duct from the air cleaner base. Copyright Safari 4x4 Engineering Pty Ltd Melbourne Victoria Australia – www.safari4x4.com.au Page 5 of 8...
Page 6
Apply sealant over the pop rivets to seal the pop rivets. Clean-up excess sealant to ensure a neat finish. Pop Rivet Copyright Safari 4x4 Engineering Pty Ltd Melbourne Victoria Australia – www.safari4x4.com.au Page 6 of 8...
Page 7
Re-install the air cleaner base, guiding the air cleaner inlet adaptor into the air entry hose, fasten the air cleaner housing using standard mounting bolts. Copyright Safari 4x4 Engineering Pty Ltd Melbourne Victoria Australia – www.safari4x4.com.au Page 7 of 8...
Page 8
N.B: It is the installer's responsibility to ensure that all connections are water tight. Copyright Safari 4x4 Engineering Pty Ltd Melbourne Victoria Australia – www.safari4x4.com.au Page 8 of 8...