Page 2
Remove the following in accordance with the factory service manual: Air Cleaner Assembly • RHS Mud Flap • RHS Guard Liner • RHS Guard Insulator • Copyright Safari 4x4 Engineering Pty Ltd Melbourne Victoria Australia – www.safari4x4.com.au Page 2 of 12...
Page 3
Remove and discard: • Air Deflector Using a sharp knife remove and discard the perforated section from the guard panel template (item 16) as shown. Copyright Safari 4x4 Engineering Pty Ltd Melbourne Victoria Australia – www.safari4x4.com.au Page 3 of 12...
Page 4
Copyright Safari 4x4 Engineering Pty Ltd Melbourne Victoria Australia – www.safari4x4.com.au Page 4 of 12...
Page 5
(item 4). If necessary raise the position of the snorkel body on the A-pillar to achieve adequate clearance. Copyright Safari 4x4 Engineering Pty Ltd Melbourne Victoria Australia – www.safari4x4.com.au Page 5 of 12...
Page 6
6mm. Drill the three A-pillar panel holes to 8mm diameter with a step drill or 8mm drill bit. Deburr and paint holes. Copyright Safari 4x4 Engineering Pty Ltd Melbourne Victoria Australia – www.safari4x4.com.au Page 6 of 12...
Page 7
(Item 3) to the A- pillar with three self-tapping screws (Item 5). Remove and discard the air intake duct from the air cleaner base. Copyright Safari 4x4 Engineering Pty Ltd Melbourne Victoria Australia – www.safari4x4.com.au Page 7 of 12...
Page 8
5.0mm holes through the air cleaner base and into the air cleaner inlet adaptor. Remove the adaptor and deburr the holes. Copyright Safari 4x4 Engineering Pty Ltd Melbourne Victoria Australia – www.safari4x4.com.au Page 8 of 12...
Page 9
The drain valve can permit water to enter the air intake. Safari advises that the drain valve should be sealed to ensure a watertight installation. Copyright Safari 4x4 Engineering Pty Ltd Melbourne Victoria Australia – www.safari4x4.com.au Page 9 of 12...
Page 10
Re-install the air cleaner base, guiding the air cleaner inlet adaptor into the air entry hose, fasten the air cleaner housing using standard mounting bolts. Copyright Safari 4x4 Engineering Pty Ltd Melbourne Victoria Australia – www.safari4x4.com.au Page 10 of 12...
Page 11
Copyright Safari 4x4 Engineering Pty Ltd Melbourne Victoria Australia – www.safari4x4.com.au Page 11 of 12...
Page 12
N.B: It is the installer's responsibility to ensure that all connections are water tight. Copyright Safari 4x4 Engineering Pty Ltd Melbourne Victoria Australia – www.safari4x4.com.au Page 12 of 12...