Introduction; Carton Inventory - Chamberlain LA 400PKGU Installation Manual

CARTON INVENTORY

NOT SHOWN: Documentation packet
LA400DC
Pull-to-Open Bracket
Gate Operator
(with a 6 foot cable attached)
HARDWARE INVENTORY
NOTE: Hardware quantities shown below are for LA400DC. Quantities are doubled for LA400DCS.
Flat Washer 5/16" (1) Hex Nut 5/16"-18 (1)
Lock Washer 5/16" (1)
Hex Nut 3/8"-16 (3)
OPTIONAL ACCESSORIES (ORDERED SEPARATELY)
Push-to-Open Bracket (Model 50-19503)
If your application requires the gate to be pushed open, a push-to-open
bracket is required (refer to accessories).
Expansion Board (Model K1D8387-1CC)
Large Metal Control Box for Solar Applications
(Model XLSOLARCONTU)
Required for solar installations (batteries not included). Requires two
33AH batteries, battery tray, and solar battery harness (refer to
accessories).

INTRODUCTION

Standard Control Box with 2 Batteries and
hardware bag (watertight connector (4),
30 amp fuse (2), mounting bolt,
washer (4), and wire nut (3))
Gate Bracket
Post Bracket
Warning Signs (2)
Keylock Cap
Hex Bolt 5/16"-18 x 1-1/2" (1)
Carriage Bolt 3/8" x 5-15/16" (2)
Pull-to-Open Bracket
Plug-in Transformer
Hex Bolt 3/8"-16 x 1-1/2" (1)
5
LA400DCS ONLY
Motor Cable
Six Conductor,
40 feet (12.2 m)
Gate Bracket
Junction Box
Gate Operator
LiftMaster Monitored Retro-Reflective Photoelectric Sensor
Key (2)
Pin (2)
Hairpin Clip (2)
Post Bracket
Terminal Block
Connector
Flat Washer 3/8" (3)
Lock Washer 3/8" (3)