D-Link DIR-825 User Manual page 183

DIR-825 AC1200 Wave 2 MU-MIMO Wi-Fi Gigabit Router
with 3G/LTE Support and USB Port
User Manual
Figure 140. The window for changing the settings of the router's port.
In the opened window, specify the needed parameters:
Parameter
Speed
To enable the needed data transfer modes, move relevant switches to the right.
Data transfer mode.
Auto
Select the value to enable autonegotiation.
selected, the Autonegotiation Modes and Flow control sections
are displayed.
Select the 10M-Half, 10M-Full, 100M-Half, or 100M-Full value
to manually configure speed and duplex mode for the selected port:
10M-Half: Data transfer in just
•
can be either sent or
of up to 10Mbps.
10M-Full:
Data transfer in two directions simultaneously
•
(data can be sent and received at the same time)
maximum possible
100M-Half: Data transfer in just
•
can be either sent or
of up to 100Mbps.
100M-Full:
Data transfer in two directions simultaneously
•
(data can be sent and received at the same time)
maximum possible
Autonegotiation Modes
Page 183 of 249
Configuring via Web-based Interface
Description
one direction at a time
received) at the maximum possible
rate of up to 10Mbps.
one direction at a time
received) at the maximum possible
rate of up to 100Mbps.
When this value is
(data
rate
at the
(data
rate
at the