D-Link DIR-825 User Manual page 177

DIR-825 AC1200 Wave 2 MU-MIMO Wi-Fi Gigabit Router
with 3G/LTE Support and USB Port
User Manual
You can specify the following parameters:
Parameter
Name
Enable
Type
VLAN ID
Untagged Ports
Tagged Ports
Click the APPLY button.
To edit an existing VLAN, select the relevant line in the table. On the page displayed, change the
parameters and click the APPLY button.
To remove an existing VLAN, select the checkbox located to the left of the relevant line in the table
and click the DELETE button (
A name for the VLAN for easier identification.
Move the switch to the right to allow using this VLAN.
The type of the VLAN.
Untagged NAT: The VLAN of this type is an external
•
connection with address translation. It is mostly used to
transmit untagged traffic.
VLAN ID field and the Tagged Ports section are not
displayed. Only one VLAN of this type can exist in the
system.
Tagged NAT: The VLAN of this type is an external
•
connection with address translation. It is mostly used to
connect to the Internet. Later the network which identifier is
specified in the VLAN ID field is used as an interface to
create a WAN connection (on the Connections Setup /
WAN page).
Ports section is not displayed.
Bridge: The VLAN of this type is a transparent connection
•
between an internal port and an external connection. It is
mostly used to connect IPTV set-top boxes.
An identifier of the VLAN.
The section includes the ports and Wi-Fi networks that can be added
to the VLAN.
To add an element, select the checkbox located to the left of it.
To remove an element, deselect the checkbox located to the left of
it.
Select an available value to assign it to this VLAN. To do this, select
the checkbox located to the left of the relevant port.
).
Page 177 of 249
Configuring via Web-based Interface
Description
When this value is selected, the
When this value is selected, the Untagged