Lumascape Centria C4 LS1010 Install Instructions

Surface-mounted spotlight

Centria C4

Surface-Mounted Spotlight

READ ALL SAFETY INSTRUCTIONS FIRST

› Follow instructions carefully, failure to do so will void warranty.

› Ensure installation complies with local law and applicable standards.

› Input voltage: Line Voltage 120/277 Vac, 60 Hz

Low Voltage 30 to 48 Vdc

› Only use Lumascape power supply, control equipment and leader

cables.

› Ensure mains input power is surge protected.

› Never make connections whilst the power is connected.

ARCHITECTURAL & FACADE LIGHTING

lumascape.com

National Electric Code, ANSI/NFPA 70 or

› Do not make modifications or alter the product.

› Keep luminaire and connections clean and free of debris and moisture.

› It is the installers responsibility that the installation is adequately

sealed to avoid moisture ingress.

Products and specifications are subject to change without notice.

LS1015

WARNING

Install in accordance with

the Canadian Electrical Code,

Part I (CEC), CSA C22.1

IN0182US-230516

Table of Contents

Do you have a question about the Centria C4 LS1010 and is the answer not in the manual?

Page 1 › It is the installers responsibility that the installation is adequately Low Voltage 30 to 48 Vdc sealed to avoid moisture ingress. › Only use Lumascape power supply, control equipment and leader cables. › Ensure mains input power is surge protected.
Page 2 Centria C4 Surface-Mounted Spotlight LS1015 Open Luminaire Loosen the four screws and remove In the base drill out gland holes as the lid and open the luminaire. required. Install Gland Drill the hole for the gland. Feed supply cable through gland and tighten.
Page 3 To Light Engine To Light Engine Conductor colours shown are for a standard Lumascape leader cable. Gasket Seal Close Luminaire Re-attach lid to base, making sure the seal is correctly placed between the two components. Seal lumascape.com...
Page 4 Centria C4 Surface-Mounted Spotlight LS1010 Aim Luminaire Using an Allen key adjust the luminaire’s tilt and rotation. Loosen the screws to adjust and tighten to lock luminaire into place. Luminaire Tilt Luminaire Rotation Wiring Designation Low Voltage 30 to 48 Vdc Line Voltage 120/277 Vac –...

Centria c4 ls1015