Expanding 1St Device Row - Siemens SIPROTEC 5 V8.83 Manual

[dweinzei-030211-01.tif, 2, --_--]
Figure 5-1
5.2.1.2

Expanding 1st Device Row

Preparation
NOTE
i
i
Reordered modules are not contained in the original device configuration. Use DIGSI to perform the corre-
sponding extension in the Hardware and Protocols Editor.
Carry out the steps described in this chapter if you wish to expand an installed device later on with expan-
sion modules.
Shut down the device.
²
Use the screwdriver to carefully bend the left and right spring clips on the rear plate terminals outwards.
²
Completely detach the wired current and voltage terminal blocks from the device.
²
Remove all communication lines.
²
Remove the plastic screw covers.
²
Remove the device.
²
Expand the cut-out in the control cabinet.
²
Then continue with assembly.
²
Assembling the Devices
Remove the bus cover from the extreme right-hand module of the device to be expanded.
²
SIPROTEC 5, Hardware Description, Manual
C53000-G5040-C002-M, Edition 12.2021
Device Row of a Flush-Mounting Device
Working on the Device
5.2 Expanding Modular Devices
185