Mitel 480 Quick Install Manual page 2

Connecting to Power and the Network
Required Items for connecting to Power and the Network:
PoE (Power over Ethernet) Adapter. One Ethernet cable and AC power cable included.
l
Ethernet cable for connecting IP Phone to PoE Adapter (included with phone)
l
Note: This configuration requires a PoE adapter and two Ethernet cables.
Refer to Connecting to Power over Ethernet on page 1 if your network wall port
supports Power over Ethernet.
1
Connect to Power and the Network:
1. Connect one end of ETHERNET CABLE A to the Ethernet port on the IP Phone.
2. Connect the other end of ETHERNET CABLE A to the DATA AND POWER OUT port on the PoE
adapter.
3. Connect one end of ETHERNET CABLE B to the DATA IN port on the PoE adapter.
4. Connect the other end of ETHERNET CABLE B to a network wall port.
5. Connect power from the PoE adapter to an appropriate power source. After a few
seconds, the IP Phone powers on and runs through a series of system tests.
2
2 3
5
A
B
Connecting to a Computer (Optional)
The IP Phone supports connecting to a PC or laptop.
Required Items for connecting the IP Phone to a computer:
Computer
l
Ethernet cable for connecting IP Phone to computer (not included)
l
1
4
2
Connect to a Computer:
1. Follow instructions Connecting to Power over Ethernet on page 1 or Connecting to Power and
the Network on page 2.
2. Connect one end of ETHERNET CABLE C to the PC port on the IP Phone.
3. Connect the other end of ETHERNET CABLE C to the Ethernet port on a PC or laptop.
3
C
3