Table of Contents
Advertisement
6
PLAY
6.1 Power-on/Auto standby/Auto wakeup
Switch on
1. Connect the soundbar and subwoofer to power by using the
supplied power cords.
2. On the soundbar, press
→ "HELLO" is displayed.
→ The subwoofer is connected to the soundbar automatically.
Connected:
NOTES:
−
Use the supplied power cord only.
−
Before switching on the soundbar, make sure that you have
completed all other connections (See "TV connection" and "Digital
device connection" in the "Connect" chapter).
Auto standby
If the soundbar is inactive for more than 10 minutes, it will switch
to standby mode automatically. "STDBY" is displayed. The
subwoofer also goes to standby, and
Next time you switch on the soundbar, it returns to the last
selected source.
Auto wakeup
In standby mode, the soundbar will wake up automatically when
•
the soundbar is connected to your TV through the HDMI
ARC connection and your TV is switched on;
•
the soundbar is connected to your TV through an optical
cable and audio signals are detected from the optical cable.
10
10
POWER
to switch on.
turns solid white.
turns solid amber.
6.2 Play from the TV source
With the soundbar connected, you can enjoy TV audio from the
soundbar speakers.
HDMI ARC
OPTICAL
1. Make sure that your TV is set to support external speakers
and the built-in TV speakers are disabled. Refer to the owner's
manual of your TV for more information.
2. Make sure that the soundbar has been properly connected
to your TV (See "TV connection" in the "CONNECT" chapter).
3. To select the TV source, press
the remote control.
→ "TV": The TV source is selected.
•
In the factory settings, the TV source is selected by
default.
NOTES:
−
If the soundbar is connected to your TV through both an HDMI
cable and an optical cable, the HDMI cable is selected for the TV
connection.
6.2.1 TV remote control setup
To use your TV remote control for both your TV and the soundbar,
check that your TV supports HDMI-CEC. If your TV does not
support HDMI-CEC, follow the steps under "TV remote control
learning".
HDMI-CEC
If your TV supports HDMI-CEC, enable the functions as instructed
in your TV user manual. You can control the volume +/-, mute/
unmute, and power on/standby functions on your soundbar
through the TV remote control.
TV remote control learning
1. On the soundbar, press and hold
is displayed.
→ You enter the TV remote control learning mode.
2. Within 15 seconds, do the following on the soundbar and your
TV remote control:
a) On the soundbar: press one of the following buttons +, -,
+ and - together (for the mute/unmute function), and
b) On your TV remote control: press the desired button.
→ "WAIT" is displayed on the soundbar.
→ "DONE": The function of the soundbar button is
learnt by your TV remote control button.
on the soundbar or TV on
and + until "LEARNING"
.
Advertisement
Table of Contents
